Glowshift Air Pressure Gauge Bedienungsanleitung PDF herunterladen

Tinted Series 200 PSI Air Pressure Gauge

For Product Numbers: GS-T13

Wire Harness Color Code

Red:

12v Ignition Source (+) (switched)

Orange:

12v Switched Headlamp Source (+) (optional)

Black:

Vehicle Ground ( - )

1. Disconnect the vehicle's negative battery cable.

Gauge Installation:

2. This gauge has a standard 1/8

NPT port for monitoring

pressures up to, but not exceeding 200PSI. Run an airline

from a compressor, air tank or pressurized system or device

to the installation location of the gauge. Connection sizes

may vary from device to device. Also, if more than one

component is going to be monitored then additional gauges

may be necessary. Check your device’s instruction manual

for proper pressure monitoring devices, connection

instructions and sizes as well as operation.

Connecting the Power Wire Harness

3. To make the wiring of your gauges easier you can

purchase an expandable circuit. This component easily fits

into your fuse panel and provides an additional fused power

wire for accessories such as gauges. The expandable circuit

is available for purchase at www.GlowShift.com.

4. Using automotive grade wiring (18 gauge); connect the

red wire to a positive 12 volt ignition (switched) source. It

may be connected to the fuse panel, an accessory wire, or

any positive 12 volt source that turns on and off with the

ignition.

5. Using automotive grade wiring (18 gauge); connect the black

wire to any good (unpainted) ground connection. You may also

route a wire directly to the negative side of the vehicle’s battery.

6. The Night Time Dimming feature decreases the brightness of

the gauge face by 30%. Connect the orange wire to the 12 volt

positive headlamp source. This allows the mode to be activated

when the headlights come on. This step is optional and will not

affect operation of the gauge if it is omitted.

 Note: Do not connect the orange wire to a dimmer

wheel. This will cause the gauge lighting to flicker.

7. Reconnect the vehicle's negative battery cable.

 Power on the vehicle to ensure the gauge is functioning

properly.

1 2

For Product Numbers: GS-T13 1

Inhaltsverzeichnis

Seite 1 - For Product Numbers: GS-T13

Tinted Series 200 PSI Air Pressure Gauge For Product Numbers: GS-T13 Wire Harness Color Code Red: 12v Ignition Source (+) (switched) Orange: 12v Sw

Seite 2

Additional Installation Information & Material Requirements  GlowShift Gauges Approved Conductor Wires: Successfully installing GlowShift Gauge

Kommentare zu diesen Handbüchern

Keine Kommentare

Glowshift Air Pressure Gauge Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Zubehör fürs Wasser Glowshift Air Pressure Gauge herunter. GlowShift Air Pressure Gauge User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Zubehör fürs Wasser Glowshift Air Pressure Gauge